is recommended for residential irrigation applications, to boost the pressure from the city water or a well pump.



When the pressure available is insufficient it is necessary to install a boosting system. FLUX-BOOST starts and stops according to the user’s needs. It replaces the traditional pressure switch/tank systems, offering more advantages such as:

• Easy installation
• Reduced dimensions
• Constant flow
• Low maintenance required
• No need to install pressure tanks
• Pump protection against running dry, with automatic reset


FLUX-BOOST is made up of a water pump and an electronic pump controller which is used for: Residential irrigation applications when is necessary to boost the pressure coming from the city water or a well pump.

Technical Specifications

• Voltage: 115/230 V.
• Water resistant
• Outdoor use
• Dimensions: see page 7
• Working temperature: 32° -104° F
• Connections: 1” standard
• Maximum working pressure: 95 psi
• Minimum flow rate: 0.5 gpm

How it works

The FLUX-BOOST monitors the flow rate of the water running through and protects the pump against dangerous working conditions like running dry.
When a tap is opened and the water demand exceeds the minimum starting flow, FLUX-BOOST starts the pump and keeps it running, delivering constant flow, even when capacity request is low.
FLUX-BOOST stops the pump when the demand is below 0.5 gal/min. In case of a leak on the system (less than 0.5 gal/min) FLUX-BOOST will never start the pump avoiding useless power consumption.

Features and Benefits

• FLUX-BOOST’s body made of technopolymer with a built-in check valve.
• FLUX-BOOST comes available with different pumps to boost incoming pressures up to 70 psi higher. For selection chart see page 6.
• Friction loss is extremely low, allowing the use of the FLUX-BOOST in applications with required flows up to 50 gpm.
• The special valve guarantees the pump continuous operation.
• Circuit board is easy to replace and available in 115/230 V.